ACD -
Automatic Call Distributor A special facility of a PABX or
Central Office switch that automatically routes incoming calls to
the next available or longest idle agent or attendant in a line
hunt group.
AGC - Automatic Gain
Control Electronic circuit which automatically increases the volume
when someone is speaking quietly and drops the volume when someone
is speaking loudly, to keep the transmitted signal constant.
Analog Single Line Station - An extension
port on a PABX/KSU that will allow a standard household type phone
to interface with the system. (POTS).
BOM
- Beginning of Message A short electrical pulse provided
by a digital announcer when used in certain 4 wire E & M modes.
The pulse alerts the PABX that the Beginning of a Message is coming.
Butt Set - a sophisticated one piece telephone used by technicians
to diagnose telephone lines or equipment.
Carbon Transmitter
(Handset) - The microphone
of a telephone handset which uses carbon granules and a diaphragm.
The diaphragm responds to voice and varies the pressure on the granules
and hence, their resistance.
C.O./CO - Central
Office A main telephone office where switching equipment is housed
and customer lines originate. Also contains trunk line connections
to other Central Offices. A C.O. line is a phone line coming from
the Central Office and terminating at the user’s premise.
Centrex - A name for
an umbrella service offering of the local telephone company. Customers
lease a portion of the Central Office switch to create a centralized
point of control and routing. In concept, Centrex is providing similar
features to a PABX.
CNG - CalliNG - 1100 Hz .5 second tone
generated every 3.5 seconds by fax machines
Contact Closure - Contacts that when
"closed" connect a pair of wires together and disconnects
the wires when "open". A doorbell button is a simple example
of a momentary contact closure.
CPC - Calling Party Control (Disconnect
Supervision) A short break in the line current in the called party’s
phone line when the calling party hangs up. Not available on PABX’s.
DID -
Direct Inward Dialing is a feature allowing callers to directly
reach a PABX extension without an operators assistance.
Distinctive Ringing - (also known as ringmate, custom ring, identifying
ring master) - Different patterns of ringing that allow a user to
identify the source of the call, outside, or inside (intercom) or
who the call is for. Usually two burst or three burst with different
durations.
DSL - Digital Subscriber Line
DTMF -
Dual Tone Multi-Frequency (Touch Tone) Audible tones which
conform to North American Telephone Standards. These are generated
by push-button telephones to dial telephone numbers, as well as
to provide control or data input to voice processing systems. Especially
significant in the operation of Viking automated attendants and
fax/data line sharing devices.
E2 Memory
(See Non-Volatile)
E & M - Control
(4 wire E & M), (the receive and transmit leads of the signaling
system) An equipment signaling system usually used in PABX applications
with a digital announcer. This interface control scheme is standard
equipment on most Viking announcers.
Earth Ground - A wire conductor that
terminates in the earth for electrical purposes.
FCC - Federal Communications
Commission
Ground Start Line
- A type of call signaling.
In this scheme, when a call is routed to a subscriber, the phone
company will apply a ground signal on the TIP side of the line even
before a ring signal is sent. By detecting this signal, phone systems
can immediately determine that the line is about to be in use, and
avoid call crashing.
Hook Switch Flash or Switch Hook
Flash - A signal originated by momentarily depressing
the switch hook on a single line phone. Typically used for accessing
C.O. or PABX features.
Hz - Hertz
Indicates the frequency (number of cycles per second) of alternating
current such as ringing voltage or Touch Tone signals.
Intercept -
To stop a telephone call directed to an improper telephone
number, and redirect that call to an operator or recording.
Industry Canada - (Formally DOC) is
the equivalent of U.S. FCC.
ISDN - Integrated
Services Digital Network An emerging international standard that
defines interfaces for simultaneous voice and data transmission
through a single channel over the public network.
ISDN Terminal Adapter - An interface
between an ISDN line and a computer. Often these provide 1 or 2
analog POTS output ports.
KSU - Key Service Unit
A central control cabinet serving many multi-button key telephones.
Contains equipment which enables the user to pick up and hold PABX
or Central Office lines and provide flashing line, steady, busy
and wink hold signals. Dial intercom service is also an option.
LED - Light emitting
diode
Loop Current -
(typically 20 to 50 Ma) Current that flows from the C.O.
when a telecom device goes off hook.
Loop Start Line - A
type of calling signal that relies on a telecom device to allow
DC current to flow when it goes into an off hook condition. The
C.O. or PABX senses this current and intercepts it as a request
for service. Also known as "POTS".
MOH - Music On Hold
N.O. /N.C. - Normally
Open/Normally Closed Contact
"No KSU" - A phone containing
all control functions normally associated with a KSU, thus not requiring
a KSU.
Non-Volatile E2 Memory -
Memory that will not be lost from a power failure: Does not
need battery backup.
OPX - Off Premise Extension
A telephone line from the phone system terminated in a different
building than the phone system.
PABX - Private Automatic
Branch Exchange Phone system used to switch telephones between extensions
and to outside lines. For incoming and outgoing (dial 9) calls.
PBX - (See PABX)
PCB - Printed Circuit Board
POTS - Plain Old Telephone Service (See C.O. Analog Single Line
Station, Loop Start Line)
Rack Mount Equipment
which is designed to mount in a standard steel framework consisting
of parallel pairs of steel channel verticals spaced 19" and
drilled for mounting screws.
RAD/RAN Device - A Record/ANnounce device
such as a Digital Announcer.
RAN Trunk/RAN Circuit -
A Record/ANnounce trunk or circuit that connects the telephone
system to a record/announce device.
REN -
Ringer Equivalency Number 1 REN = The energy to ring 1 Plain
Old Telephone. The REN number can be found on the FCC label on the
device. The total ringer load on a line is equal to the sum of all
the REN numbers of all the telephone devices connected to the line.
Ring Back Tone -
The sound you hear when the phone you call is ringing.
Ringdown Circuit - A circuit connecting
2 devices so that when one device goes off hook it automatically
rings the other device.
Ring Generator - A circuit producing
AC voltage that is higher that 50 VRMS and has a frequency of 20
Hz.
Ring Signal -
Same as ringback
Ring Trip - The process of stopping
the AC ring signal and connecting the voice path at the C.O. when
the ringing telephone is answered.
Ring Voltage - A 20 Hz AC voltage higher
than 50V superimposed on the phone line to ring bells, activate
ring detectors in phone systems, faxes, modems, etc.
RJ-11, RJ-14, RJ-21X, RJ-25 - Request Fax back Document No. 839
RMS - Root
Mean Square. This is simply a fancy way of describing the average
voltage level of an audio signal.
RS232 - An
Electronic Industry Association (EIA) standard that defines a computer
interface for connecting serial communication devices such as printers
and modems.
66 Block -
A terminal block where up to 4 sets of up to 25 pairs of
wire can be interconnected. The installer uses a special "punch
down" tool to connect the wires.
SLT - Single Line Telephone
SOHO - Small
Office/Home Office An acronym for a new class of employment where
the employee may be performing part or all of their work at home
in a small office set up.
Subscriber Line - The telephone line connecting the local Telco
Central Office to the customer’s telephone instrument or telephone
system.
Talk Battery -
DC voltage supplied by the C.O. to the subscriber’s loop
to operate the telephone equipment.
Telco - Local
Telephone Company
Terminal Device - Telephone, phone system,
fax, modem, etc. capable of terminating an analog phone line.
Trunk - A
telephone communication path or channel between two points, one
usually being a Central Office.
Trunk Port - An
input on a PABX or KSU that is used to interface the system with
C.O. lines.
UCD -
Uniform Call Distributor An ACD programmed to distribute calls to
agents or representatives on a basis other than the next available.
(See ACD). Each person in the group receives the same number of
calls.
UPS - Uninterruptible Power Supply Provides
power to your phone equipment, computers, etc., in the event of
a commercial power failure.
VOX - Voice Operated
eXchange Your voice starts it. When you stop speaking its stops. |